How much does it cost to install a double-sided fireplace?

How much does it cost to install a double-sided fireplace?

A double-sided or multi-sided gas fireplace insert runs from $1,200 to more than $8,000, not including labor or installation. A two-sided ventless gas fireplace runs from about $1,000 to $2,500.

What is the vent on the outside of my fireplace for?

Keeping a fire lit takes different factors including air and fuel for burning. The products of combustion include water vapor and carbon monoxide. An outside air source is a vent that provides fresh air to feed the fire.

Can you have two flues one chimney?

A single chimney can safely have multiple flues inside the chimney, each flue venting an appliance, fireplace, or other device, provided that the chimney was properly constructed, including the necessary spacing or sealant between the individual flues.

Does rain go down a chimney?

Unless a chimney has a cowling, rain often comes down its relatively small aperture. But all chimneys have a bend built into them to prevent any downdraught. Any normal rain will be absorbed by the insides of the chimney and prevented from going all the way down by this ledge.

What is a Class 2 chimney?

Class 2 flue. A conventional flue but is only 5 inches in diameter. The range of gas fires that can be fitted to a class 2 flue is slightly reduced to that of a Class 1 flue. Pre-cast flue. Usually found in more recently built properties.

Do I need permission to take down a chimney breast?

Planning permission is required when: – removing the shared chimney stack and pot/s on a party wall. These tend to be external, above the roof level and part of the street character, and therefore susceptible to the Town and Country Planning Act 1990.

Can I remove my chimney stack?

External chimney stack removal can be done from outside the building and, if done carefully, need not disrupt any internal decoration. Removing an internal chimney breast, however, is a mess job. On the ground floor, the stack should be taken down to ground level.

Should I remove my chimney stack?

Removing your chimney can create more space in your property. No plans to use it in the future. If you do not intend on using the chimney, you may decide to have it completely removed.

Do you need a structural engineer to remove a chimney breast?

If you discover that the chimney breast you want to remove is real, then you will almost certainly need to contact a structural engineer. Actual chimney breasts form part of the structure of a house – once removed, the addition of support beams may need to be incorporated to support any masonry above.

Is a chimney structural?

A majority of chimneys are independently supported and are not structural to the walls or roof. However, it isn’t uncommon for chimneys to be in the middle of a home or stretch from the foundation, through multiple stories, and out the roof. Sometimes there are ties connecting the chimney to parts of the framing, too.

How much does it cost to repair a chimney flue?

Minor chimney flue repairs cost $250 to $1,000 to replace cracked tiles or fix mortar joints. Extensive repairs such as resurfacing or relining a flue cost $2,000 to $7,000 on average.

Do you really need a chimney liner?

However, if you’re not using your fireplace and your chimney acts solely as a vent for your furnace or water heater, you may not need to have a liner installed. Homeowners with gas or electric inserts most likely do not need a new liner because those types of fuel don’t produce enough heat to damage a masonry chimney.

How do you Rebrick a chimney?

Individual chimney bricks that have a small crack or two can be repaired with a high-heat mortar and a caulk gun. Clean out the crack with the edge of a putty knife or with a screwdriver. Sweep the crack clean with a wire brush. Squeeze high-heat mortar into the crack as far as possible.